Mercedes-Benz SL 65 AMG Black Series Operator's Manual page 91

230_AKB; 1; 42, en-US
d2ureepe,
Closing when a door window is blocked
G Warning!
Make sure that nobody can become
trapped and be seriously or even fatally
injured when closing a door window with
greater force or without automatic reversal
function.
If the upward movement of a door window is
blocked during the closing procedure, the
door window will stop and open slightly.
X
Immediately after the door window has
stopped because it was blocked, pull and
hold the respective switch upwards until
the door window is fully closed. The door
window closes with greater force.
If the door window is blocked again and opens
slightly:
X
Immediately after the door window was
blocked, pull and hold the respective
switch upwards until the door window is
fully closed. The door window closes
without automatic reversal function.
G Warning!
Pressing and holding the switch to close the
door window immediately after it had been
blocked two times will cause the door
2008-11-27T15:37:19+01:00 - Seite 89
Version: 2.11.7.1
window to close without any reversal
function for as long as you hold the switch.
Opening and closing the rear side
windows
X
Opening: Open the door window.
X
Press switch or again.
1 2
The corresponding rear side window will
open completely.
X
Closing: Close the door window.
X
Pull and hold switch or 2.
1
The corresponding rear side window will
move upwards until you release the switch.
Closing with KEYLESS-GO
When locking the vehicle, you can
simultaneously close the windows.
X
Press and hold the lock button on an
outside door handle ( Y page 67) until the
windows are completely closed.
X
Release the lock button on the outside door
handle to interrupt the closing procedure.
Controls in detail
Power windows
Synchronizing power windows
The windows must be synchronized after the
battery has been disconnected or if the
windows cannot be fully closed (express
operation).
Each window must be synchronized
separately.
X
Close all doors.
X
Switch on the ignition.
X
Pull and hold switch or ( Y
1 2
until the respective window is closed.
The window opens again slightly.
X
Pull and hold the respective switch once
more immediately until the window is
completely closed.
X
Hold the respective switch for
approximately 1 second.
The window is synchronized.
page 88)
Z
89