Mercedes-Benz SL 65 AMG Black Series Operator's Manual page 149

230_AKB; 1; 42, en-US
d2ureepe,
i Indicator lamp flashes immediately
1
the first time the signal transmitter button
is programmed. If this button has already
been programmed, the indicator lamp will
start flashing after 20 seconds.
X
Step 5: After indicator lamp
from a slow to a rapidly flashing light,
release the hand-held remote control
button and the signal transmitter button.
X
Step 6: Press and hold the just-trained
signal transmitter button (2,
observe indicator lamp 1.
If indicator lamp stays on constantly,
1
programming is complete and your device
should activate when the respective signal
transmitter button (2,
3
and released.
i If indicator lamp flashes rapidly for
1
approximately 2 seconds and then turns to
a constant light, continue with
programming steps 8 through 12 as your
garage door opener may be equipped with
the "rolling code" feature.
X
Step 7: To program the remaining two
signal transmitter buttons, repeat the steps
above starting with step 3.
2008-11-27T15:37:19+01:00 - Seite 147
Version: 2.11.7.1
Rolling code programming
To train a garage door opener (or other rolling
code devices) with the rolling code feature,
follow these instructions after completing the
"Programming" portion (steps 1 through 6) of
this text. A second person may make the
changes
1
following training procedures quicker and
easier.
X
Step 8: Locate the "training" button on the
garage door opener motor head unit.
or 4) and
3
i
Exact location and color of the button may
vary by garage door opener brand.
Depending on manufacturer, the "training"
button may also be referred to as "learn"or
"smart" button. If there is difficulty locating
or 4) is pressed
the transmitting button, refer to the garage
door opener Operator's Manual.
X
Step 9: Press the "training" button on the
garage door opener motor head unit.
The "training light" is activated.
You have 30 seconds to initiate the
following two steps.
X
Step 10: Return to the vehicle and firmly
press, hold for 2 seconds and release the
programmed signal transmitter button
(2, or 4).
3
X
Step 11: Press, hold for 2 seconds and
release same signal transmitter button a
Controls in detail
Useful features
second time to complete the training
process.
i Some garage door openers (or other
rolling code equipped devices) may require
you to press, hold for 2 seconds and
release the same signal transmitter button
a third time to complete the training
process.
X
Step 12: Confirm the garage door
operation by pressing the programmed
signal transmitter button (2,
3
X
Step 13: To program the remaining two
signal transmitter buttons, repeat the steps
above starting with step 3.
Gate operator/Canadian programming
Canadian radio-frequency laws require
transmitter signals to "time-out" (or quit)
after several seconds of transmission which
may not be long enough for the integrated
signal transmitter to pick up the signal during
programming. Similar to this Canadian law,
some U.S. gate operators are designed to
"time-out" in the same manner.
If you live in Canada or if you are having
difficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4 with
the following:
or 4).
Z
147