Mercedes-Benz SL 65 AMG Black Series Operator's Manual page 150

230_AKB; 1; 42, en-US
d2ureepe,
Controls in detail
Useful features
X
Step 4: Press and hold the signal
transmitter button (2, 3, or 4). Do not
release this button until it has been
successfully trained.
X
While still holding down the signal
transmitter button (2, 3, or 4), "cycle"
your hand-held remote control button
as follows: Press and hold button
2 seconds, then release it for 2 seconds,
and again press and hold it for 2 seconds.
Repeat this sequence on the hand-held
remote control until the frequency signal
has been learned.
Upon successful training, indicator lamp
will flash slowly and then rapidly after
1
several seconds.
X
Proceed with programming step 5 and
step 6 to complete.
i Upon completion of programming the
integrated remote control, make sure you
retain the hand-held remote control that
came with the garage door opener, gate
operator or other device. You may need it
for use in other vehicles, for future
programming of an integrated remote
control, or simply for continued use as a
hand-held remote control to operate the
respective device in other situations.
148
2008-11-27T15:37:19+01:00 - Seite 148
Version: 2.11.7.1
Reprogramming a single signal
transmitter button
To program a device using a signal
transmitter button previously trained, follow
these steps:
X
Switch on the ignition.
6
X
Press and hold the desired signal
for
6
transmitter button (2,
release the button.
Indicator lamp will begin to flash after
1
20 seconds.
X
Without releasing the signal transmitter
button, proceed with programming starting
with step 3.
Operation of integrated remote control
X
Switch on the ignition.
X
Select and press the appropriate
integrated signal transmitter button (2,
or 4) to activate the remote controlled
3
device.
The integrated remote control transmitter
continues to send the signal as long as the
button is pressed – up to 20 seconds.
Erasing the integrated remote control
memory
i If you sell your vehicle, erase the codes of
all three channels.
X
Switch on the ignition.
X
Simultaneously press and hold outer signal
transmitter buttons
or 4). Do not
3
approximately 20 seconds, until indicator
lamp flashes rapidly. Do not hold for
1
longer than 30 seconds.
The codes of all three channels are erased.
Programming tips
If you are having difficulty programming the
integrated remote control, here are some
helpful tips:
Check the frequency of hand-held remote
R
control
5
side of the remote). The integrated remote
control is compatible with radio-frequency
devices operating between 280-390 MHz.
Put a new battery in hand-held remote
R
control 5. This will increase the likelihood
of the hand-held remote control sending a
faster and more accurate signal to the
integrated remote control.
and 4, for
2
(typically located on the reverse