Mercedes-Benz SL 65 AMG Black Series Operator's Manual page 259

230_AKB; 1; 42, en-US
d2ureepe,
X
On the wheel to be changed, loosen but do
not yet remove the wheel bolts
(approximately one full turn with wheel
wrench 2).
G Warning!
When turning the wheel wrench to loosen
the wheel bolts, make sure you position
your hands on the wrench in such a way
that you avoid injury to yourself, such as
scraping your hands against the wheel.
Make sure turning the wheel wrench will
not scratch or damage the wheel rim.
The jack take-up brackets are located directly
behind the front wheel housings and in front
of the rear wheel housings.
G Warning!
The jack is designed exclusively for jacking
up the vehicle at the jack take-up brackets.
Make sure the jack arm is fully seated in the
jack take-up bracket.
If you do not position the jack correctly in
the jack take-up bracket, the vehicle can
fall off the jack and seriously or fatally injure
you or others.
! Do not position the jack on the body of
the vehicle, as this may cause damage to
the vehicle.
2008-11-27T15:37:19+01:00 - Seite 257
Version: 2.11.7.1
Take-up bracket
3
Jack
4
Ratchet
5
X
Attach reversible ratchet to jack
5
such a way that the word UP can be seen.
X
Place jack on firm ground.
4
X
Position jack under take-up bracket
4
so that it is always vertical as seen from
3
the side, even if the vehicle is parked on an
incline.
X
Turn ratchet up and down until jack
5
is fully seated in take-up bracket
jack base evenly meets the ground.
X
Jack up the vehicle until the wheel is a
in
4
maximum of 1.2 in (3 cm) from the ground.
X
Unscrew uppermost wheel bolt and remove
it.
X
Replace this wheel bolt with the alignment
bolt supplied with the vehicle tool kit.
X
Remove the remaining bolts.
! Do not place wheel bolts in sand or dirt.
This could result in damage to the wheel
bolts and wheel hub threads.
X
Remove the wheel.
Practical hints
Wheel change
4
and the
3
Z
257