Pepperl+Fuchs VisuNet GXP RM-GXP1100-22F Manual page 45

VisuNet GXP
VisuNet GXP
System Installation
Mechanical Installation
Figure 3.15
4. Press the DPU and housing together at the top end of the system. From the back of the
housing, place one screw in the hole at the upper-left corner and one screw in the hole at
the upper-right corner of the housing.
5. Tighten the two screws with a torque of 6 Nm.
6. Repeat the previous step with all other screws, following a diagonal pattern.
45
Display panel bolts lined up with the cutout holes on the inner frame