Pepperl+Fuchs VisuNet GXP RM-GXP1100-22F Manual page 42

VisuNet GXP
VisuNet GXP
System Installation
Mechanical Installation
3. Guide the open wire end of the cable through the hole.
4. Place the M16 counter nut over the end of the cable.
5. Pull the socket into the housing and tighten it with the M16 counter nut. Tighten the nut with
a torque of 5 Nm.
6. Protect the cable from mechanical damage by fastening it with a cable tie.
7. Route the cable through the cable gland on the TCU/PCU. Install the wire ends per the table
below.
42