Pepperl+Fuchs VisuNet GXP RM-GXP1100-22F Manual page 28

VisuNet GXP
VisuNet GXP
System Installation
Mechanical Installation
2. Put the gland nut and ferrule of the cable gland on the cable and slide them a few meters
down the length of the cable away from the pedestal. Keep the nut and ferrule on the cable.
They will be tightened in a later installation step.
3. Route the cables through the cable glands, up through the pedestal tube, and out through
the top of the pedestal.
4. Pull the cable through the pedestal so that 50 cm of the cable is hanging out of the top of the
pedestal.
5. Repeat the preceding steps for each cable that must be routed through the pedestal.
The pedestal is now ready for connection.
28