Figure 16. Removing the battery
Steps
1. Loosen the captive screw (M1.6x2) that secures the battery-connector bracket to the palm-rest assembly.
2. Lift the battery-connector bracket off the system board.
3. Using the pull tab, disconnect the battery cable (BATT) from the system board.
4. Remove the six screws (M1.6x3.5) that secure the battery to the palm-rest assembly.
5. Lift the battery off the palm-rest assembly.
Installing the battery
CAUTION:
The information in this installation section is intended for authorized service technicians only.
Removing and installing Field Replaceable Units (FRUs)
43