Advertisement
Step 3: Add an Extension Arm (b) to each side of the Main Arm (a). Lock each Extension Arm into place at the
desired width using a Set Screw (g). Tighten the Set Screw with the Allen Key (i) as shown in Diagram 3 below.
Step 4: A Component Holder (c) fits into the track on the inside of each Extension Arm (b). Next, a Knob (h)
passes through the slot in the Extension Arm from the outside and threads into the hole in each Component Holder
as shown in Diagram 4 below.
a
Determine how you will mount the VMTV to your TV Wall Mount: There are two different methods to attach
the VMBR component bracket to the wall mount. It is recommended that you use Method 1 described in steps
5 through 8. You may also use Method 2 described in steps 9 through 11. Method 2 will be easier if you already
have a television on your TV Wall Mount.
Method 1
Step 5: First find the Plastic Cap Bottom from the TV Wall Mount. There is a
pre-punctured hole in the bottom that you must push out as shown in Diagram 5.
Step 6: Place the 8 mm Diameter Bolt (m) down through the TV Platter in place of the bolt provided with the TV
Wall Mount as shown in Diagram 6 below.
Step 7: Next place the Plastic Cap Bottom onto the TV Wall Mount assembly.
Step 8: Finally add the hardware to the bottom of the 8 mm Diameter Bolt (m) in the following order: Tube Spacer
(n), Washer (o), Component Bracket Assembly, Plastic Spacer (p), Washer (o), and the 8 mm Nut (q) as shown in
Diagram 6 below. Adjust the width and height to fit your component and the assembly is complete.
Method 2
Step 9: Place the Mount Bracket (j) over the Arm of the TV Wall Mount as shown in Diagram 7 below.
Step 10: Next place both 6 mm Diameter Bolts (k) down through the Mount Bracket (j) so that the square neck of
the bolts fit into the square holes in the bracket also shown in Diagram 7.
Step 11: Add the component bracket to the assembly so that the two 6 mm Bolts (k) fit down through the two
square holes in the Main Arm (a) and tighten a 6 mm Nut (l) onto each 6 mm Bolt as shown in Diagram 7 below.
Diagram 6
Plastic Cap
Bottom
o
Sanus Systems 3785 Lexington Ave. North, Saint Paul, MN 55126 800.359.5520 www.sanus.com
Diagram 3
g
b
m
n
Component Bracket
Assembly
p
o
q
a
c
Threaded Hole
Diagram 7
Component Bracket
Assembly
Diagram 4
b
h
Diagram 5
Hole
Arm
j
l
k
032204
Advertisement
