Sanus Systems Vision Mount VMBR Assembly Instructions

Thank you for purchasing a Vision Mount product. This product is designed to hold a VCR, DVD player, or cable / satellite
box under a VMBR television wall mount. It will accommodate one component up to 15 lbs. Check carefully to make sure
there are no missing or defective parts. Never use defective parts. Improper installation may cause damage or serious injury.
If you do not understand these directions, or have any doubts about the safety of the installation, please call a qualified
contractor or contact Sanus Systems at 800.359.5520 or visit www.sanus.com. We can quickly assist you with installation
questions and missing or damaged parts. Replacement parts for Sanus products purchased through authorized dealers will
be shipped directly to you.
Required Tools: Ratchet or wrench set
Supplied Parts:
(1) Main Arm - a
(2) 17 mm Wide Foam Pad - d
(2) Set Screw - g
(1) Mount Bracket - j
(1) 8 mm Diameter Bolt - m
Step 1: Place the 2 Square Foam Pads (f) onto the 2 square surfaces on the bottom of the Main Arm (a) as shown
in Diagram 1 below.
Step 2: Place a 17 mm Wide Foam Pad (d) onto the vertical side of each Component Holder (c). Next place a 15
mm Wide Foam Pad (e) onto the horizontal side of each Component Holder as shown in Diagram 2 below.
Sanus Systems 3785 Lexington Ave. North, Saint Paul, MN 55126 800.359.5520 www.sanus.com
Assembly Instructions for Vision Mount VMBR
(2) 15 mm Wide Foam Pad - e
(1) Plastic Spacer - p
Diagram 1
f
a
(2) Extension Arm - b
(2) Knob - h
(2) 6 mm Diameter Bolt - k
(1) Tube Spacer - n
(1) 8 mm Diameter Nut - q
(2) Component Holder - c
(2) Square Foam Pad - f
(1) Allen Key - i
(2) 6 mm Diameter Nut - l
(2) Washer - o
Diagram 2
c
d
e