Before Receiving Repair Requests; Service Inspection List - Mitsubishi Electric JT-SB116JH2-S-NA Handbook

11. Before receiving repair requests

Frequently asked question
Air blow is too weak to dry hands
quickly.
Water leaks from the product.
Air does not blow immediately after
turning on the power and inserting
hands.
Warm air does not blow.
The product has an abnormal odor.

12. Service inspection list

Location
Electric wiring
Lamps
Operation
Heater
Wall installation
1 Check if the filter is clogged.
2 Isn't the air speed switch set at the STANDARD position?
1 Check if the drain tank is filled up. (Empty the drain tank.)
*Note: Drain water will overflow onto the floor when the drain tank is
filled up beyond its capacity.
2 Is the drain tank installed properly?
Initial setting takes 1.5 seconds after turning on the power. Operation
is disabled in the meantime.
1 Is the heater switch turned ON?
2 Is the room temperature lower than 89.6°F (32°C)?
1 Check if the drain tank is filled up. (Empty the drain tank.)
2 Check the inside of the drain tank for any foreign matter. (Remove it.)
3 Is the inside of the side cover cleaned up?
Are lead wire connectors connected securely?
Is the wiring correct?
Do the power lamp (LED1), the heater lamp (LED2) (with the
heater switch ON), and blue indicators (LED10, 11) come on?
Does it operate properly?
Isn't there any abnormal noise, vibration, etc?
Is warm air blown?
Isn't there clearance between the product and the back wall?
─ 15 ─
Response
Inspection Item Check Result