Mitsubishi Electric JT-SB116JH2-S-NA Handbook page 24

(12) Blower assembly (assy)
1 Remove the blower cover. → See (8) 1 to 2, (11) 1 (Remove the side panel R clamping screw only), and
4 to 5.
Precaution
Since the blower (assy) may drop off the blower case, remove the lead wires first, and then slowly remove
the blower cover.
2 Remove the blower (assy).
Assembly precautions
• When replacing the blower (assy), attach the included fixing piece to the position, indicated by , with
the included screw (one PTT screw 4×16).
• Set the blower (assy) as the lead wire outlet comes to the position indicated by .
• The part of the lead wires covered with the white cord tube must pass through the cord bush. (Indicated
by )
Fixing piece
(13) Sensor circuit board (Lower sensor) (JT-30S3R)
1 Remove the blower (assy). → See (7) 1 and (12).
2 Unscrew the clamping screws, and remove the blower case.
(Three PTT screws 4×16, indicated by )
3 Unscrew the panel (front) and panel holder clamping screws, and
remove the panel holders L and R.
(Five PTT screws 4×16, indicated by )
Set the blower horizontally.
Blower (assy)
─ 24 ─
Align the cord bush
with the marking.
Blower case
Panel (front)
Panel holder L Panel holder R