Download  Print this page

Maintenance; Switching The Power Off Before Cleaning; Cleaning The Appliance Exterior And Hand Drying Area - Mitsubishi Electric Jet Towel JT-SB216JSH-W-E Instruction Manual

Hand dryer
Hide thumbs

Advertisement

Warning
Always turn off the power switch during maintenance work.
Failure to do so may result in an electric shock.
Do not allow water to get on the appliance.
This may cause electric shocks or malfunctions.
Only use cleaning products that are labeled as safe "Safe to use on plastics".
Cautions
Do not use any of the following cleaning materials
(They may damage the surface of the appliance, or cause discoloration or cracking.)
Solvents such as thinner or benzene
Mold and mildew removers
Nylon scourers or abrasives
Do not clean the front cover of a silver appliance with alcohol.
(This may damage the surface of the appliance, or cause discoloration or cracking.)
"Alcohol" means a disinfectant with an ethanol content of 83% or less.
Be sure to dispose of any alcohol that has collected in the drain tank.
Do not spray alcohol directly onto the appliance.
Damage to the appliance (such as rusting) is not covered by the warranty if the above cautions are not
observed.
When cleaning the appliance, use a neutral detergent. (pH: 6 8)
NOTE
The exterior of the appliance can be wiped with alcohol. (Excluding the front cover of silver models)
After cleaning with neutral detergent or alcohol, be sure to wipe away all remaining traces of the detergent or alcohol.
After wiping the appliance clean with alcohol, be sure to dispose of any alcohol that has collected in the drain tank.
Do not spray alcohol directly onto the appliance.
When using a chemical cloth, be sure to follow the instructions carefully.

Switching the power OFF before cleaning

1
Cleaning the appliance and hand drying area
2
If it is particularly dirty
Wipe with a well wrung wet cloth

Maintenance

Citrus based or other plant based detergents
1.Open
Caution
◦ Wear rubber gloves when cleaning the appliance.
Not doing so may result in injuries.
Acid, alkaline or chlorine detergents
Antiseptics
Adjusting air speed and heater
– see installation manual page 10
2.Turn the power OFF
Power
r
P o w e
switch
O N
O F F
NOTE
After cleaning with neutral detergent or alcohol,
be sure to wipe away all remaining traces of the
detergent or alcohol.
Clean the sensor area about once a week.
5
NOTE
Do not turn the power on
while hands or other objects
are inside the hand drying
area.
Hand drying area
Black wall area
Sensor
Front cover

Advertisement

Table of Contents
loading

  Also See for Mitsubishi Electric Jet Towel JT-SB216JSH-W-E