Maintenance; Turn The Maintenance Switch On Before Cleaning; Cleaning The Unit And Hand Drying Area - Mitsubishi Electric Jet Towel JT-SB116JH-G-NA Instruction Manual

Warning
Do not allow water to get on the unit.
This may cause electric shocks or malfunctions.
Only use cleaning products that are labeled as safe "Safe to use on plastics".
Cautions
Do not use any of the following cleaning materials.
(They may damage the surface of the unit, or cause discoloration or cracking.)
Solvents such as thinner or benzene
Mold and mildew removers
Nylon scourers or abrasives
Do not clean the front panel with alcohol.
(This may damage the surface of the unit, or cause discoloration or cracking.)
※ "Alcohol" means a disinfectant with an ethanol content of 83% or less.
※ Be sure to dispose of any alcohol that has collected in the drain tank.
※ Do not spray alcohol directly onto the unit.
Damage to the unit (such as rusting) is not covered by the warranty if the above cautions are not observed.
When cleaning the unit, use a neutral detergent. (pH: 6-8)
NOTE
The exterior of the unit can be wiped with alcohol. (Excluding the front panel)
After cleaning with neutral detergent or alcohol, be sure to wipe away all remaining traces of the detergent or alcohol.
After wiping the unit clean with alcohol, be sure to dispose of any alcohol that has collected in the drain tank.
※ Do not spray alcohol directly onto the unit.
When using a chemical cloth, be sure to follow the instructions carefully.

Turn the maintenance switch ON before cleaning

1
1. Open the service
Service panel

Cleaning the unit and hand drying area

2
If it is particularly dirty (at least once a week)
Wipe with a well-wrung wet cloth

Maintenance

panel.
Caution
Always turn on the maintenance switch during maintenance
work.
Wear rubber gloves when cleaning the unit.
Not doing so may result in injuries.
Acid, alkaline or chlorine detergents
Citrus-based or other plant-based detergents
Antiseptics
2. Turn the maintenance
switch on.
* The blower does not turn on while cleaning.
NOTE
After cleaning with neutral detergent or alcohol,
be sure to wipe away all remaining traces of the
detergent or alcohol.
Clean the sensor area about once a week.
− 4 −
NOTE
After cleaning, turn the
Maintenance
maintenance switch off.
switch*
Do not turn the maintenance
switch off while hands or
other objects are inside the
hand drying area.
ON
Hand drying area
Black wall area
Sensor
Front panel