Before Receiving Repair Requests; Service Inspection List - Mitsubishi Electric JT-S1AP-W-NA Handbook

10. Before receiving repair requests

Frequently asked question
1 The hand dryer does
not blow air even
though hands are
inserted. (It may not
stop blowing air in
the case of 3.)
2 The hand dryer does
not blow warm air.
3 Air blow is too weak to dry hands quickly.

11. Service inspection list

Location
Electric wiring
Operation
Power light
Filter
Wall installation
The power light is not
turned on.
Cases other than the
above
The heater switch is
not turned on.
Ambient temperature
is low.
Are lead wire connectors connected securely?
Is the wiring correct?
Does the hand dryer operate properly?
Isn't there any abnormal noise, vibration, etc.?
Does the light (LED) come on?
Is the filter inserted into the proper position?
Isn't there any gaps between the product and the back wall?
1 If the power wires are disconnected, securely connect
them to the terminal block.
2 If the circuit breaker is OFF, turn it ON.
3 The sensor area may get dirt, clean up the sensor area.
1 If the heater switch (SW1-2) is OFF, turn it ON.
2 When the room temperature is 18°C or lower, the hand
dryer, which is equipped with the simple heater, does not
blow sufficiently warm air.
If the filter is clogged, clean it up.
Inspection Item
─ 14 ─
Response
Check Result