The following pictures show JT-SB116JH2-W-NA.
( 1 ) Turn off the power supply.
1 Stop the operation.
2 Turn off the circuit breaker on the distribution board.
(2) Front panel
1 Draw out the tank assembly (assy).
2 Unscrew the clamping screws, and remove the front panel.
(Two special (spl) screws 4×16, indicated by )
(3) Power cable
1 Unscrew the clamping screw, and remove the terminal block (TB)
cover.
(One PTT screw 4×6, indicated by )
2 Unscrew the clamping screws, and disconnect the power cable
leads.
(Two screws, indicated by )
─ 17 ─
Tank assy
Front panel
Ground wire
Terminal block
Power cable
TB cover
Power cable
Terminal block