Web Interface; The Remote Console - Tripp Lite B050-000 Owner's Manual

Ip remote access unit

Hide thumbs Also See for B050-000:

Table of Contents

Use terminal software (e.g. hyperterm or minicom) to connect to the B050-000. Reset the B050-000, and immediately press

the "ESC" key. You will see a "=>" prompt. Enter the command "config", and press the "ENTER" key. You will be asked

to adjust the IP auto configuration, the IP address, the net mask, and the default gateway. Pressing the "ENTER" key

without entering values does not change settings. The gateway value has to be set to 0.0.0.0 (for no gateway) or any other

value for the IP address of the gateway. After the confirmation, the B050-000 performs a reset using the new values.

Web Interface

The B050-000 may be accessed using a standard Java enabled web browser. You may use the HTTP protocol or a secure

encrypted connection via HTTPS. Just enter the configured IP address of the B050-000 into your web browser. The initial

Note: Changing these settings to user-specific values is strongly recommended and can be done on the

"User Management" page (see the Section called "Users And Groups" in Chapter 6).

The Remote Console is the redirected screen, keyboard and mouse of the remote host system in which the B050-000 is

installed. The web browser, which is used for accessing the B050-000, has to supply a Java Runtime Environment version

1.1 or higher. However, it is strongly recommended to install Sun JVM 1.4. The Remote Console will behave exactly the

same way as if you were sitting directly in front of the screen of your remote system. That means that both the keyboard

and mouse can be used in the usual way. Open the console by selecting the preview picture on the main site of the HTML

front-end. Figure 1-6 shows the top of the Remote Console.

1. Quick Start Guide

Parameter

Password

Table 1-3. Standard User Settings

Value

super

pass

Table of Contents