Unit Reset - Tripp Lite B050-000 Owner's Manual

Warning: This process is not reversible and might take some minutes. Make sure the B050-000's power
supply will not be interrupted during the update process, because this may cause an unusable device.
• Thirdly, after the firmware has been stored, the B050-000 will reset automatically. After about one minute you
will be redirected to the Login page and requested to login once again.
Warning: The three-stage firmware update process and complete consistency check make a mistake in
updating the firmware almost impossible. However, only experienced staff members or administrators should
perform a firmware update. Make sure the B050-000's power supply will not be interrupted!

Unit Reset

This section allows you to reset specific parts of the device. This involves the both keyboard and mouse, the video engine
and the B050-000 itself. Resetting the card itself is mainly needed to activate a newly updated firmware. It will close all
current connections to the administration console and to the Remote Console. The whole process will take about half a
minute. Resetting subdevices (e.g. video engine) will take a few seconds only and does not result in closing connections.
To reset a certain B050-000 functionality click on the button "Reset" as displayed in Figure 6-40.
Note: Only the user "super" is allowed to reset the B050-000.
6. Menu Options
Figure 6-40. Unit Reset
87