Front Side Connectors And Indicators - Tripp Lite B050-000 Owner's Manual

Front Connectors and Indicators
System Port:
Attach the system cable with the gray connector to this port.
Power/Status LED:
• LED off: the B050-000 has no or not enough power
• LED blinking: the B050-000 is booting up (if this process takes longer than one minute, the reason may
be a lack of power)
• LED on: the B050-000 is up and running
If the B050-000 is connected via USB-only and the Power/Status LED does not stop blinking after one minute, the
B050-000 may not be receiving enough power via the USB port. In that case attach the enclosed power supply to the
B050-000.
DC 5V (Power Supply):
• Attach the enclosed power supply to the B050-000
• Voltage: 5V
• Current: 1.5 A
RJ45 Ethernet:
• Cat5 UTP cables can be connected to the B050-000 using this standard RJ45 jack
3. Installation
System Port
Power/Status LED
Figure 3-2. Front Connectors and Indicators
15
DC 5V Ethernet