Tripp Lite B050-000 Owner's Manual page 57

Device Authentication
To use the Drive Redirection, you have to authenticate on the B050-000 using a valid username and password. Permission
to change the virtual disc configuration is necessary.
Navigation Buttons
Connect/Disconnect:
To establish the drive redirection, press the Connect button once. If all the settings are correct, the status bar
displays that the connection has been established, the Connect button is disabled and the Disconnect button is
enabled. On an error, the status line shows the error message. The drive redirection software tries to lock the local
drive before it is redirected. That means that it tries to prevent the local operating system from accessing the drive
as long as it is redirected. This may also fail, especially if a file on the drive is currently open. In the case of a
locking failure, you will be prompted if you want to establish the connection anyhow. This should not be a serious
problem when the note above is respected. If the write support is enabled, a drive which is not locked might be
damaged by the Drive Redirection.
With the Disconnect button, a connection via Drive Redirection connection is stopped.
Exit/Hide:
If the Exit button is pressed, the Drive Redirection software is closed. If a Drive Redirection connection is active,
the connection will be closed before the application terminates.
6. Menu Options
Figure 6-15. Device Authentication
57