Initial Network Configuration
The B050-000 network interface is configured with the parameters shown in Table 1-1.
Warning: If the DHCP connection fails on boot up, the B050-000 will not have an IP address.
If this initial configuration does not meet your local requirements, adjust the values as needed. You may either configure
the B050-000 via serial interface or use the setup tool that can be found on the CD-ROM delivered with this package.
B050-000 Setup Tool
The setup tool is used to determine the IP address assigned to the B050-000 by the DHCP server or to change the device's
initial network configuration.
Main Window
1. Quick Start Guide
Parameter
IP auto configuration
IP address
Netmask
Gateway
IP access control
Table 1-1. Initial Network Configuration
Figure 1-4. B050-000 Setup Tool (Windows Version)
Value
DHCP
—
255.255.255.0
none
none
6