PAT DS 50 Troubleshooting Manual page 5

DS50 TROUBLE SHOOTING MANUAL LEVEL 3
NOTICE
THIS TROUBLE SCHOOTING MANUAL "DS 50 - LEVEL 3" IS DESIGNED TO ASSIST
THE SERVICE OR MAINTENANCE PERSONNEL IN ADJUSTING THE EXISTING
CALIBRATION DATA AND TRANSFERRING CALIBRATION DATA INTO A REPLACEMENT
DS 50 CENTRAL UNIT.
THIS TROUBLE SHOOTING MANUAL DOES NOT REPLACE ANY CALIBRATION
INSTRUCTION. THEREFORE IT SHOULD NOT BE USED AS A CALIBRATION
MANUAL.
IN ORDER TO PERFORM THE ADJUSTMENTS IN THIS TROUBLE
SHOOTING MANUAL YOU REQUIRE A SPECIAL TOOL SET. THE TOOL SET CONSISTS
OF THE PROFORT 803 HAND TERMINAL, THE DATAMAN S4 EPROM PROGRAMMER,
THE INTERFACE BOARD, A SET OF CABLES AND A PRE-PROGRAMMED E-PROM.
WE ASSUME THAT REGULAR MAINTENANCE AND SERVICE TOOLS AND A DIGITAL
VOLTMETER ARE AVAILABLE ON SITE.
THIS TROUBLE SHOOTING MANUAL DS 50 - LEVEL 3- IS THE CONTINUATION OF
TROUBLE SHOOTING MANUAL DS 50 - LEVEL 1- AND -LEVEL 2- AND ASSUMES
THE KNOWLEDGE OF THE CONTENT OF THE PREVIOUS LEVELS .
WE SUGGEST THAT ONLY TRAINED MAINTENANCE AND SERVICE PERSONNEL
PROCEED WITH THE TROUBLE SHOOTING DESCRIBED IN THIS MANUAL.
TSM DS 50-003/REV.B/031-300-190-003/12-02-96
5