DS50 TROUBLE SHOOTING MANUAL
10. TRANSFERRING EEPROM DATA
Transmit data to the EEPROM of the replacement unit:
•
Switch the truck power off (No power to DS 50)
•
Switch DATAMAN S4 off.
•
Connect the serial interface cable into the connector of the DATAMAN S4.
Connect the DB 9 connector of the interface cable into the DB 9 ribbon cable
connector of the DS 50 interface.
•
Switch DATAMAN S4 on and switch the truck power (DS 50 power) on.
Wait for minimum of 10 seconds.
The display will prompt twice (>) with two tones and the cursor flashes.
•
Press the white key >send<
the display indicates:
--> enter 00000,000FF using the key board
--> Press the >ENTER< key to confirm
•
The DATAMAN S4 checks the data and responds with a single tone and the
prompt.
•
At the completion of the transmission the DATAMAN S4 responds with:
After completion of the data transfer refer to section 2.1 and 2.2 to verify the
system function and calibration. Also refer to Trouble Shooting Manual 1 and 2 for
basic set up of the PAT DS 50 Overload Warning System.
TSM DS 50-003/REV.B/031-300-190-003/12-02-96
>SEND INTEL
00000,0FFFF (in example)
1 dual tones = DATA transmitted correctly
5 dual tones = Error in the data transmission
40
LEVEL 3