DS50 TROUBLE SHOOTING MANUAL
10. TRANSFERRING EEPROM DATA
Receive data from EEPROM:
•
Switch the truck power off (No power to DS 50)
•
Switch DATAMAN S4 off.
•
Connect the serial interface cable into the connector of the DATAMAN S4.
Connect the DB 9 connector of the interface cable into the DB 9 ribbon cable
connector of the DS 50 interface.
•
Switch DATAMAN S4 on and switch the truck power (DS 50 power) on.
Wait for minimum of 10 seconds.
The display will prompt twice (>) and the cursor flashes.
•
Switch DATAMAN S4 off and immediately on again. The DATAMAN S4 will now
receive the data out of the EEPROM. Note: The DATAMAN S4 will transmit the
data one more time to the DS 50 to test the received data. Please be patient
as the transmission can take a little while.
•
At the completion of receiving and testing data the DATAMAN S4 responds with:
•
The prompt and the cursor flashes to continue transferring data or to repeat the
receiving function.
TSM DS 50-003/REV.B/031-300-190-003/12-02-96
2 dual tones = DATA received correctly
6 dual tones = Error in the data transmission
37
LEVEL 3