PAT DS 50 Troubleshooting Manual page 38

DS50 TROUBLE SHOOTING MANUAL
10. TRANSFERRING EEPROM DATA
At this point it is possible to burn and secure the data into an EPROM (27C256 PAT
tested and approved EPROMS only). The EPROM can be downloaded to a PC file
using the DATAMAN S4.
Note: Either a copy EPROM or a PC file must be forwarded immediately after calibration
adjustment to
If no adjustment has changed the data and no EPROM copy is desired skip to "Transmit
data to the DS 50" in this section.
Copy data into EPROM
• Switch the truck power off (No power to DS 50)
• Disconnect the serial interface cable from the DB 9 ribbon cable connector of the
DS 50 interface.
• Plug the blank EPROM into the DATAMAN S4 EPROM socket. Refer to the user
manual for correct insertion.
• Press the green key >BURN<
The display indicates :
if not
--> Enter >00000 - 07FFF=00000< on the last line and press >ENTER<
--> The display scrolls through the addresses while burning the EPROM.
--> Display returns with the prompt and a tone.
TSM DS 50-003/REV.B/031-300-190-003/12-02-96
PAT-Equipment Corp.,Inc.
Attn. Software Dept.
1665 Orchard Drive
Chambersburg, PA 17201
U.S.A.
Microchip 27C256
13.00V Burn pin 1
00000 - 07FFF=00000
38
LEVEL 3