PAT DS 50 Troubleshooting Manual page 27

DS50 TROUBLE SHOOTING MANUAL
6. ADJUSTING OVERLOAD CUT OFF FACTOR
continuation
indicate >D-RLFCT= n: < ?
Note: n= calibration
YES
Enter your calculated correction factor in % x 100.
Example: +5.00% = +500
The correction factor is limited to +/- 500.
Then press the >CR< key to enter the value.
Press the key >K< to return to the start up menu.
Go to section 3.2 and observe the display while you
repeat the cut off test for the actual length step.
problem corrected
YES
TSM DS 50-003/REV.B/031-300-190-003/12-02-96
Does
the display
NO
value.
--2.75% = -- 275
Is the
now?
The End
Scroll through the lines by pressing the enter key >CR<
NO
Return to section 5 and identify the problem.
27
until the line is displayed.
LEVEL 3