Master/Slave Mode - Chauvet DJ IMIDATOR SPOT 160 User Manual

Master/Slave Mode

The Master/Slave mode allows a single Intimidator Spot 160 product (the "master") to control the actions of
one or more Intimidator Spot 160 products (the "slaves") without the need of a DMX controller. The master
product will be set to operate in either standalone mode or with the IRC-6, whereas the slave products will
be set to operate in slave mode. Once set and connected, the slave products will operate in unison with the
master product.
Configure the products as indicated below.
Slave products:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Run Mode.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Slave.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select from Slave1, Slave2, Slave3, or Slave4.
• Select Slave1 for 100% synchronized actions.
• Select Slave2, Slave3, and/or Slave4 for delayed actions, creating a wave effect.
7. Press <ENTER>.
8. Connect the DMX input of the first slave product to the DMX output of the master product.
9. Connect the DMX input of the subsequent slave products to the DMX output of the previous slave
product.
10. Finish setting and connecting all the slave products.
Master product:
1. Set the master product to operate in standalone mode or with the IRC-6.
2. Make the master product the first product in the DMX daisy chain.
• Configure all the slave products before connecting the master to the daisy chain.
• Never connect a DMX controller to a DMX string configured for Master/Slave operation
because the controller may interfere with the signals from the master.
• Do not connect more than 31 slaves to the master.
Page 16 of 20 Intimidator Spot 160 User Manual Rev. 2
Operation