Maintenance And Cleaning; General Cleaning Instructions - FLORABEST FTP 400 D3 Translation Of The Original Instructions

Check this by placing the pump
fully by hand and then lower it
again. In this case, you can see
whether the pump switches on
and off.
- Also ensure that the separation
height adjustment (7) is not too
small. In the case of a separa-
tion distance which is too small,
trouble-free functioning cannot
be guaranteed.
before the pump switches off.
adjustment (
(see „Operational start-up").
Manual mode/flat suction
In manual mode, the pump does not switch
is bypassed.
adjustment (7).
Monitor the pump constantly when
in manual mode. Switch the pump
off immediately (disconnect from
the mains) if no more water is be-
age if the pump runs dry.
7) is not installed
6)
Maintenance and
Cleaning
-
Clean and maintain your equipment regu-
and long durability.
Ask our service centre to car-
ry out any work that is not
described in these instruc-
tions. Use only original parts.
There is a risk of injury!
Pull out the power plug before
is a risk of electrocution or of injury
from moving parts.

General cleaning instructions

• In case of transport for utilization in
different locations, the pump must be
cleaned with clear water after every
use.
• In case of stationary installation, the
to be checked regularly (at the latest
every three months).
present in the pump casing (
- switch (
• Regularly remove sludge from the pit
base (at the latest every 3 months) and
also clean the shaft walls
-
GB IE
(
6) with clear water.
NI
6) is
3).
11