Servicing the Laser
Service
Operation
Replacing the
Aperture
Replace
Desiccant
Replacing the
Emission Light
© 2019 Cutting Edge Optronics
Figure 1-4: Laser Tack Locations
The following table lists the recommended order of procedures to successfully
perform service operations on the laser. Refer to the sections contained in this
service manual for detailed instructions.
Table 1-2: Service Action Table
1.
Remove Cover (page 28)
2.
Aperture Removal (page 13)
3.
Aperture Replacement (page 14)
4.
Tack Components (page 6)
5.
Install Cover (page19)
6.
Laser Optimization (page 43)
1.
Desiccant Replacement (page 14)
1.
Remove Cover (page 28)
2.
Emission Light Replacement (page 16)
3.
Tack Components (page 6)
4.
Install Cover (page19)
Order of procedures
7
Patara II and Iklwa II Service Manual
Chapter 1: General Instructions