Appendix; What To Do If; The Machine Doesn't Work; I Can't Print - Roland monoFab ARM-10 User Manual

Appendix

What to Do If

The Machine Doesn't Work

Symptom Points to check
Is the machine turned on?
Has the connector cable come loose?
The machine does not
output print data
Does the computer have enough disk
space?

I Can't Print

Symptom Points to check
Does the weight of the job exceed the
maximum printable resin volume?
Is the area of the object in contact with the
platform too small?
The job drops into the
liquid material vat
Has the initial printing height of the
printing platform been adjusted?
Is the object's center of gravity heavily
skewed?
Action
Turn on the machine.
Connect the cable.
The computer was unable to obtain the disk space required to output
data.
Increase the amount of free disk space by deleting unnecessary files,
etc.
Action
Reduce the size of the object.
Make the object lighter by reducing the thickness of areas where resin
is thick.
Increase the area (shape) of the object in contact with the platform.
Increase the number of supports.
Appropriately adjust the initial printing height.
Change the shape of the object so that the center of gravity is in the
center of the job.
Increase the number of supports.
55
Refer to
p. 11
"Roland DG Start-up page"
http://startup.rolanddg.com/
—
Refer to
monoFab Player AM Help
—
—
monoFab Player AM Help
p. 26
—
monoFab Player AM Help
Corresponds to [monoFab Player AM Ver.1.40] or later