Check The Actual Printing Status - Roland monoFab ARM-10 User Manual

Check the Actual Printing Status

In the actual work area, the object is inverted as shown in the following figure. You can use the
(the inversion of the object) prior to actually printing.
70mm
Work area
MEMO
• [View Printing Position]
The
[View Printing Position]
You can switch the display between
+ platform].
The actual work area is inverted as shown in the figure below
Work area
70mm
function can be used from any tab.
[View Printing Position]
button
[Printing position] and
Printing platform plane
39
function to check the printing orientation
[Printing position
Corresponds to [monoFab Player AM Ver.1.40]
Output (Printing)
or later