Table of Contents
Advertisement
3.
Wear rubber gloves (included or commercially available) and protective eyewear (commercially available).
MEMO
Adjust the height of the ARM-10's legs before use. Adjust the legs so that the resin will collect on the printing platform side (the back of the machine) when the
amount of resin in the liquid material vat gets low. For details, refer to the
4.
Open the lid of the resin bottle, and pour resin into the liquid material vat.
MEMO
•
The amount of resin required for printing can be shown in monoFab Player AM.
•
Resin volume of 100 ml is equivalent to approximately 110 g when using a commercially available measuring cup.
5.
Close the lid of the resin bottle securely.
NOTE
If the lid of the resin bottle is not closed securely, the remaining resin may deteriorate or cure, making it impossible to use.
"Roland DG Start-up page"
Do not fill with resin beyond the FULL
line of the rear side.
FULL
30
(http://startup.rolanddg.com/).
Corresponds to
[monoFab Player AM Ver.1.40]
Output (Printing)
or later
Advertisement
Table of Contents
