Table of Contents
Advertisement
5.
Scrape off any cured resin that has stuck to the printing platform using the included
NOTE
Take care not to scratch the surface of the printing platform with the edge of the metallic scraper. If the surface is scratched, it may not be possible to print.
MEMO
The printing platform is a consumable part. After several print jobs, resin may work its way into the fine corrugations on the printing platform surface, making it
impossible to print. If this happens, it is recommended that the printing platform be replaced. Contact Roland DG Corp. or the authorized Roland DG Corp. dealer
from whom you purchased the machine.
6.
Soak a rag in ethanol and wipe away any remaining resin.
Be sure to remove any resin adhering to the printing platform. Allowing the resin to remain can cause the printing platform to deteriorate and can lead to printing
failure.
7.
Hold the printing platform handle, and then insert the printing platform retaining screw into the slot.
"metallic spatula."
47
Corresponds to
[monoFab Player AM Ver.1.40]
Output (Printing)
or later
Advertisement
Table of Contents
