Use; Presentation Of The Regulation - Zodiac Z300 Series Instructions For Installation And Use Manual

• Remote on/off control
- Function: connect a remote «on/off» button
- Thanks to a zero-potential free contact, without 230 V - 50 Hz polarity, connect the cable to the busbar between
terminals 7-8,
- Activate the command by pressing
, then press 3 seconds on
pressing :
• Remote control unit
- Function: control the heat pump remotely.
- Refer to the instructions for the remote control unit for connections.

3. Use

3.1 Presentation of the regulation

Cold mode
(only on D models)
Symbol Designation
Water flow
Ambient air temperature
Operation indicator
Defrost indicator
On/off button
button to set and confirm parameters
value setting buttons
H0439100.B - EN - 2014-09
for 5 seconds when regulation is not on standby:
:
, press to exit.
A1-A2 : supply to the power contactor coil of the filter pump
B : filter timer
C : power contactor (3-pole or 2-pole), supplying the filter pump
D : independent connecting cable for the «heating priority» function
E : terminal
F : fuse
G : independent connecting cable for alarm contact relay
H : alarm contact relay
I : remote on/off switch
J : independent connecting cable for remote on/off control
steady
Water flow-rate ok
Adequate
During heating or air
conditioning
Defrost in progress
, select «Yes» using key
Water temperature
Setpoint temperature
flashing
Water flow too weak, high or absent
Inadequate
On standby until operating command
received
then
, then validate by
EN
/
6