Table of Contents
Advertisement
Expert Power Control NET 8x 8210 / 8211
4.3.2
Configuration - IP address
4.3.2.1
Hostname
Enter the host name of Expert Power Control NET 8x 8210 / 8211. Expert Power Control NET 8x 8210 / 8211 uses this
name to connect with DHCP server.
Special signs may destabilize your network.
All changes need a restart of the firmware to get valid.
4.3.2.2
IP Address
Here you can change the IP address of Expert Power Control NET 8x 8210 / 8211.
All changes need a restart of the firmware to get valid.
4.3.2.3
Netmask
Here you can change the netmask of Expert Power Control NET 8x 8210 / 8211.
All changes need a restart of the firmware to get valid.
4.3.2.4
Gateway
Here you can change the standard gateway of Expert Power Control NET 8x 8210 / 8211.
All changes need a restart of the firmware to get valid.
4.3.2.5
Use DHCP
Here you can set, if Expert Power Control NET 8x 8210 / 8211 shall get its TCP/IP settings directly from your DHCP server.
If DHCP is activated, Expert Power Control NET 8x 8210 / 8211 proves if a DHCP server is active inside of your LAN. Then
Expert Power Control NET 8x 8210 / 8211 requests TCP/IP settings from this server. If there is no DHCP server inside of
your network, we recommend to deactivate this function.
All changes need a restart of the firmware to get valid.
12
Configuration
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Expert Power Control NET 8x 8211 and is the answer not in the manual?
Questions and answers