Configuration - Messages - Gude Expert Power Control NET 8x 8211 Manual

Table of Contents

Expert Power Control NET 8x 8210 / 8211

4.3.4.1

HTTP Port

Here you can enter the HTTP port number, if necessary. Possible numbers are 1 ... 65534 (standard: 80). To get access to

Expert Power Control NET 8x 8210 / 8211, you have to enter the port number behind the IP address of Expert Power

Control NET 8x 8210 / 8211, e.g.: http://192.168.0.2:1720

All changes need a restart of the firmware to get valid.

4.3.4.2

Require HTTP Password

Password protected access can be activated here. In this case, a user and an admin password have to be defined.

Passwords have a maximum lengths of 15 characters.

Administrators are authorized to switch all ports and to modify the settings of Expert Power Control NET 8x 8210 / 8211 and

of all ports. The username of the admin is "admin".

Users are authorized to switch all ports but are not allowed to modify the settings of neither Expert Power Control NET 8x

8210 / 8211 nor the ports. The username of the user is "user".

If you have forgotten your password, activate the bootloader mode of Expert Power Control NET 8x 8210 / 8211, start GBL-

Conf.exe and deactivate the password request.

All changes need a restart of the firmware to get valid.

4.3.4.3

Check Password on start page

If activated, the user has to enter his password, before logging in to the webinterface.

4.3.5