Table of Contents
Advertisement
Expert Power Control 1000 / 1001
4.3.2
Configuration - IP address
4.3.2.1
Hostname
Enter the host name of Expert Power Control 1000 / 1001. Expert Power Control 1000 / 1001 uses this name to connect
with DHCP server.
Special signs may destabilize your network.
All changes need a restart of the firmware to get valid.
4.3.2.2
IP Address
Here you can change the IP address of Expert Power Control 1000 / 1001.
All changes need a restart of the firmware to get valid.
4.3.2.3
Netmask
Here you can change the netmask of Expert Power Control 1000 / 1001.
All changes need a restart of the firmware to get valid.
4.3.2.4
Gateway
Here you can change the standard gateway of Expert Power Control 1000 / 1001.
All changes need a restart of the firmware to get valid.
4.3.2.5
Use DHCP
Here you can set, if Expert Power Control 1000 / 1001 shall get its TCP/IP settings directly from your DHCP server. If
DHCP is activated, Expert Power Control 1000 / 1001 proves if a DHCP server is active inside of your LAN. Then Expert
Power Control 1000 / 1001 requests TCP/IP settings from this server. If there is no DHCP server inside of your network, we
recommend to deactivate this function.
All changes need a restart of the firmware to get valid.
8
Configuration
Advertisement
Table of Contents
Need help?
Do you have a question about the Expert Power Control 1000 and is the answer not in the manual?
Questions and answers