Chapter 5 Operation; Switching At The Device; Switching By Webinterface; Switching - Gude Expert Power Control NET 8x 8211 Manual

Expert Power Control NET 8x 8210 / 8211
5 Operation
5.1

Switching at the device

Expert Power Control NET 8x 8210 / 8211 disposes of two buttons: "select" and "ok". By pushing "select", the LED of
Power Port 1 starts blinking which means that it is selected. By pushing the button again, the next Power Port is selected. If
you want to change the switching state of the selected Power Port, push the "ok" button for two seconds.
You can check the status of the Power Ports by the color of the Power Port status LED (green=enabled/red=disabled).
5.2

Switching by Webinterface

Go to the website of Expert Power Control NET 8x 8210 / 8211. Enter the IP address of Expert Power Control NET 8x
8210 / 8211 into the address line of your internet browser:
http://"IP address of Expert Power Control NET 8x 8210 / 8211"/ and press LOGIN
5.2.1

Switching

Here you are able to switch the ports directly.
You can check the status of the Power Ports by the color of the Power Port status LED (green=enabled/red=disabled).
18
Configuration