Mitsubishi OUTLANDER Owner's Manual page 388

Maintenance
4. While holding down the tab (D), pull out the
socket (E).
5. To install the bulb, perform the removal
steps in reverse.
CAUTION
l Handle halogen lamp bulbs with care.
The gas inside halogen lamp bulbs is high-
ly pressurized, so dropping, knocking, or
scratching a halogen lamp bulb can cause
it to shatter.
l Never hold the halogen lamp bulb with a
bare hand, dirty glove, etc.
The oil from your hand could cause the
bulb to break the next time the head-
lamps are operated.
If the glass surface is dirty, it must be
cleaned with alcohol, paint thinner, etc.,
8
and refit it after drying thoroughly.
8-26
Headlamps (high-beam, except for ve-
hicles with high intensity discharge
headlamps)
1. When replacing the bulb on the right side of
the vehicle in the case of diesel-powered ve-
hicles equipped with M/T, remove the bolt
(A) holding down the washer tank spout and
move the spout towards the rear of the vehicle.
*: Front of the vehicle
2. Turn the cap (B) anticlockwise to remove it.
*: Front of the vehicle
3. Turn the bulb (C) anticlockwise to remove it.
E01009400148
*: Front of the vehicle