Mitsubishi OUTLANDER Owner's Manual page 204

Starting and driving
Gearshift lever position display
When the ignition switch is turned to the "ON" po-
sition, the position of the gearshift lever is indica-
ted in the multi-information display.
4
In addition, when the vehicle is driven with the gear-
shift lever in the "D" (DRIVE) position, the for-
ward gear number is shown.
through
4-38
If the gearshift lever position display
E00621100287 and the buzzer beeps
With the gearshift lever in the "R" (REVERSE) po-
sition, if the gearshift lever position display
blinks and the buzzer beeps, the transmission gears
have not properly engaged. To correct this situa-
tion, the following procedure must be performed.
1. Depress the brake pedal with your right foot
and place the gearshift lever in the "N" (NEU-
TRAL) position.
2. Again place the gearshift lever in the "R" (RE-
VERSE) position and confirm that the gear-
shift lever position display has stopped blink-
ing and that the buzzer has stopped beeping.
3. Repeat 1 and 2 above if the gearshift lever po-
sition display continues to blink and the buz-
zer beeps.
WARNING
l To avoid unintended vehicle movement
when the gearshift lever position display
blinks and the buzzer beeps, keep
brake pedal applied with your right foot
and do not depress the accelerator pedal.
If the gearshift lever position display is not showing
There may be a problem in the Twin Clutch SST.
If this occurs, the safety device operates and pre-
vents the vehicle from moving. Therefore, perform
the following procedure.
1. Park your vehicle in a safe place and stop the
engine.
2. Restart the engine.
If the gearshift lever position display is shown and
blinks
the vehicle can move after this procedure is per-
formed, there is no malfunction.
E00627100162
If the gearshift lever position display is not shown
and the vehicle cannot move, or if this problem oc-
curs repeatedly, have the vehicle checked by a
MITSUBISHI MOTORS Authorized Service Point
as soon as possible.
Gearshift lever positions (Manual shift
gate)
"P" PARK
This position locks the transmission to prevent the
vehicle from moving. The engine can be started in
this position.
"R" REVERSE
This position is to back up.
CAUTION
l
Never shift into the "P" (PARK) or "R"
(REVERSE) position while the vehicle is
in motion to avoid transmission damage.
"N" NEUTRAL
At this position the transmission is disengaged. It is
E00627200017
the same as the neutral position on a M/T, and
should only be used when the vehicle is stationary
for an extended length of time during driving, such
as in a traffic jam.
E00621200060