Mitsubishi OUTLANDER Owner's Manual page 120

Instruments and controls
l The display setting can be changed to the pre-
ferred units (km or miles).
Refer to "Changing the function settings
(when the ignition switch is "ON")" on page
3-17.
Average speed display
This displays the average speed from the last reset
to the present time.
There are the following 2 mode settings.
For the method for changing the average speed dis-
play setting, refer to "Changing the function set-
tings (when the ignition switch is "ON")" on page
3-17.
3
Type 1 Type 2
Manual reset mode
l When the average speed is being displayed,
if you hold down the multi-information me-
ter switch, the average speed displayed at
that time is reset.
3-12
l When the ignition switch is switched from
"ACC" or "LOCK" to "ON", the mode set-
ting is automatically switched from manual
to auto.
Although the mode setting is automatically
switched to the auto reset mode, if you
switch the mode setting to the manual reset
mode, the average speed from the last time
E00521600773
the display is reset will be displayed.
Auto reset mode
l When the average speed is being displayed,
if you hold down the multi-information me-
ter switch, the average speed displayed at
that time is reset.
l If the ignition switch is at "ACC" or
"LOCK" for about 4 hours or longer, the aver-
age speed display is automatically reset.
NOTE
l The average speed display and the average
fuel consumption display can be reset individ-
ually for the auto reset mode and manual re-
set mode.
l "---" is displayed when the average speed can-
not be measured.
l
The initial (default) setting is "Auto reset
mode".
l
The display setting can be changed to the pre-
ferred units (km/h or mph).
Refer to "Changing the function settings
(when the ignition switch is "ON")" on page
3-17.
l
The memory of the auto reset mode or man-
ual reset mode for the average speed display
is erased if the battery is disconnected.
Average fuel consumption display
This displays the average fuel consumption from
the last reset to the present time.
There are the following 2 mode settings.
For information on how to change the average fuel
consumption display setting, refer to "Changing
the function settings (when the ignition switch is
"ON")" on page 3-17.
Type 1 Type 2
The " " mark (A) in the momentary fuel gauge
shows the average fuel consumption.
Manual reset mode
l When the average fuel consumption is being
displayed, if you hold down the multi-infor-
mation meter switch, the average fuel con-
sumption displayed at that time is reset.
E00521700758