Mitsubishi OUTLANDER Owner's Manual page 352

For emergencies
Wheel covers*
To remove
Wrap the tip of the jack bar with a cloth, insert it
deeply into the notch provided in the wheel cover,
and pry the cover away from the wheel. Using the
same procedure at the other wheel cover notches,
work the wheel cover away from the wheel to re-
move it completely.
CAUTION
6
l Removing the cover with your hands may
cause injury to the fingers.
NOTE
l The wheel cover is made of plastic. Pry it
loose carefully.
6-18
To install
1. Make sure the tabs (A) of the back of the
E00801300315
wheel cover are not broken and correctly fit-
ted on the rings (B). If in doubt, do not in-
stall the wheel cover and consult your
MITSUBISHI MOTORS Authorized Service
Point.
2. Align the tyre valve stem (C) with the cut
out area (D) in the wheel cover.
NOTE
l There is a symbol (E) on the back of the
wheel cover indicating the cut out area.
3. Push the underside (F) of the wheel cover in-
to the wheel.
4. Gently push both sides (G) of the wheel cov-
er and hold them in place with both knees.
5. Gently push around the top (H) of the wheel
cover.