Palamides delta 151 Manual Instruction page 45

Optimisation menu
8.14 Stacking level compensation delay OUT (not active on the
delta705)
As the elevation table returns from the intermediate position to the pressing unit, the flaps on
the stacking level compensator are reset. Resetting the stacking level compensator is
delayed by increasing this value.
This can be necessary for spines that spread out excessively at the spine.
8.15 Welding time
This adjustment determines for how long the band is welded. Band type is selected in the
option menu. Paper or plastic film. The welding time is chosen depending on the material.
8.16 Cooling time
This adjustment determines for how long the band is cooled. Band type is selected in the
option menu. Paper or plastic film. The cooling time is chosen depending on the material.
8.17 Sheet recognition
In double stream, it could happen that products arrive offset in the delivery. Ejection of the
products can be cancelled by changing sheet recognition via a photocell.
8.18 Shingling belt speed (only in single sheet mode)
Constant speed for the shingling belt in m/sec. .
0 = automatic mode
Subject to change without notice
8
45