Palamides delta 151 Manual Instruction page 29

Setting up the machine
Adjust lower round belts of shaft 2:
1. Set the lower belts exactly below the upper belts.
Obere Rundriemen der Welle 3 einstellen:
1. Align belt (2) to the transport belt (1).
2. Align both outside belts parallel to each other. In doing so, pay attention to the
number of grooves on round belt shaft 1.
3. Use the number of grooves to adjust both outer belts. This will ensure that the
product is not fed in at an angle.
Round belt adjustment
1
2
Abb. 1040837
1
2
Wrong
Adjust lower round belts of shaft 4:
1. Place the lower belts exactly under the upper belts.
2. Repeat these steps for all up-works of the product.
Subject to change without notice
The products are driven along the course of the round belts. Set the round
belts of shaft 3 so that there is an exact allocation to the relevant shaft.
see picture 1040837
Transport belt
Round belt
3
3 Photocell
7
29