Palamides delta 151 Manual Instruction page 21

Handling and Operation
Group1 description
(1) Emergency-off
(2) Stop
(3) Start
(4) Sheet call-up
Only in connection
with an MBO folding
machine
(5) Single sheet
Only in connection
with an MBO folding
machine
(6) Speed press drive
with machine running
Inching mode
With machine stopped
(7) Preselect inching
mode
(with pressing unit
hood open)
Subject to change without notice
(1)
(2) (3) (4) (5) (6) (7)
Used to switch the equipment off immediately there is a
dangerous situation. The switch locks when pressed and
the machine can only be restarted by pulling it out (turn the
button in a clockwise direction).
Note: Data is not deleted when the emergency-off button
is pressed. This means that, after re-starting, work
continues from the point where it stopped before the
emergency-off button was activated.
Switches the machine off.
Deletes errors. This still shows on the display after
mechanical removal of a fault. The message is deleted by
pressing the stop button.
Note: Data is not deleted when the stop button is pressed.
This means that, after re-starting, work continues from the
point where it stopped before the stop button was
activated.
Starts the machine
Note: After pressing the start button, the equipment needs
a few seconds until it is operational. During this time, any
products which may be moving through the machine will be
ejected via the waste sheet deflector.
Sheet call-up to the folding machine.
With MBO Navigator connection: Deletes errors on the
folding machine.
A single sheet can be called up from the folding machine
by pressing this key, e.g. for "calibration" mode.
The speed of the press drive can be altered by turning the
inching switch so that the machine can be aligned to the
speed of the folding machine.
Note: In inching mode, the press drive runs forwards or
backwards when the switch is activated in single sheet
mode. In shingled stream mode, only forwards.
Inching mode is enabled with the hood open by pressing
this key. Speed is reduced. Switch (6) lights up and is
enabled for inching mode
Note: Function 2. Only with open hood.
This inching mode is only enabled for the press drive.
6
Abb.7677-2
21