Optimisation Menu - Palamides delta 151 Manual Instruction

Optimisation menu

8 Optimisation menu
Adjustments which deviate from the default values can be made in the optimisation menu.
8.1 Package compression
Adjustment to package compression during production.
The values lie between -200 mm and +200 mm. The higher the value
the stronger the pressure on the package.
8.2 Intermediate position
The intermediate position starts after the last product in the stack has fallen on to the
elevation table. The intermediate position is required so that the pressing rails can be
retracted.
For products which spring open, it can be necessary to lower the intermediate position so
that there is enough room for the pressing rails to retract.
The setting range lies between -200 mm and +200 mm. Ideally, after reaching the
intermediate position, the upper edge of the package is approx. 20 mm under the pressing
rails.
8.3 Pressing rails earlier / later
After reaching the intermediate position, the pressing rails move to their working position.
The package can be pressed. Depending on the format, it could make sense to move the
pressing rails to the working position earlier or later. The smaller the value, the earlier the
pressing rails are started.
Pressing rails started too soon
Picture 932
8.4 Sheet gap (only in single sheet mode)
The sheet gap in single sheet mode can be adjusted here. Adjustment made in mm.
Subject to change without notice
Pressing rails started too late
Picture 933
8
43