Setting up the machine
7.6
Shingling device
After the pressing unit, the products are taken over by the transport belts. The shingled
stream is formed at the shingling axle.
Shingle formation is automatically calculated and adjusted when the sheet is calibrated
The lower belts after the pressing unit can be adjusted in height. The shingling axle (2) is
adjusted to the product's size using the "auto calibrate" function. The shingling axle can be
readjusted in the "manual function" menu. This takes place using the manual function key on
the operating controls. The upper / lower belt pressing force must be lowered for thick
products. This takes place by turning the shingling axle by up to +/-90°. The shingling axle
is supported eccentrically.
Adjust infeed angle:
Shingling axle
Abb.1616
1. Loosen knurled screw (1)
2. Adjust lower belts (2)
3. Tighten knurled screw
Subject to change without notice
1
2
7
33