Avaya CallPilot 1006r Hardware Installation page 33

5. Connect the power cords to the monitor and plug the other end into a wall receptacle
6. Turn on the monitor.
To connect the modem to the server
1. Connect one end of the telephone cable to the modem RJ-11 jack labeled LINE.
2. Connect the other end of the telephone cable to the RJ-11 jack in the wall.
3. Connect one end of the USB cable into the modem.
4. Connect the other end of the USB cable into either the lower USB port labeled D
To connect the external SCSI tape drive
Note : The external SCSI tape drive is a plug and play device when used with the included
USB to SCSI adapter. For a High availability system you may wish to share one tape drive
between the two servers.
1. Set the SCSI ID dial switch on the tape drive to SCSI ID 6.
2. With the tape drive power switch off, connect the USB to SCSI adapter to the SCSI
3. Make sure the SCSI terminator is connected to the other SCSI connector on the
4. Plug the tape drive into the same single-point ground and A/C power as the rest of
5. Power on the tape drive.
6. Using the included USB cable, connect the USB to SCSI adapter into the lower USB
7. In the Found New Hardware Wizard dialog box, select No and click Next.
8. In the Found New Hardware Wizard dialog box, select Install from a list or specific
9. In the Found New Hardware Wizard dialog box, select Include this location in the
10. Click Next.
Avaya CallPilot® 1006r Server Hardware Installation
requirement between the power outlets of the CallPilot server and the power outlets
of the switch.
or power bar.
on the rear panel (long term) or the USB port on the front panel (short term).
Note:
If the external SCSI tape drive adapter is present, you need to use the front USB
port to connect the modem to the server.
connector on the tape drive.
tape drive.
the system.
port labeled D on the rear panel of the server. See Rear panel connectors.
New hardware is detected and the Windows Hardware Wizard is launched.
USB WIDE-LVD SCSI converter is detected.
location (Advanced) and click Next.
The installation options are displayed.
search and enter the following patch in the corresponding field: C:\PnpDrivers
\USBSCSI
Rear panel connectors
December 2010 33