Table of Contents
Advertisement
Connecting the server to power
Figure 10: 1006r server in a network
To connect the 1006r AC server to power
1.
2. Plug the other ends into an approved wall receptacle or power bar.
To start the server
1. Press the server power switch to start the server.
2. Observe the Power-On Self Test (POST) and initialization messages on the monitor.
3. Let the mini-setup sequence run until you are prompted to log on to the operating
4. Ensure that the operating system logon window appears on the monitor.
42
Avaya CallPilot® 1006r Server Hardware Installation
Warning:
Risk of personal injury, risk of hardware failure
The power outlets used by the CallPilot server and its peripheral devices must
be connected to the same single-point ground reference as the one used by the
switch with MGate cards connected to the CallPilot server. If this requirement is
not met, power transients can cause personal injury, hardware failure, or both.
See the Installation and Configuration Task List (NN44200-306) for more
information about single-point grounding requirements.
Plug the server AC power cords into the server rear panel.
system.
Note:
The system can perform multiple reboots. This is normal.
December 2010
Advertisement
Table of Contents
