Multiple Failures In The Same Array; Resetting The Controller - Adaptec SAS/SATA/SCSI RAID Controllers Installation And User Manual

Adaptec raid controller installation and users guide sas, sata, and scsi raid controllers
Table of Contents

Advertisement

Multiple Failures in the Same Array

Except in RAID 6 and RAID 60 arrays (see
same time in the same array, the data can't be recovered.
Correct the cause of the failure or replace the failed disk drives. Then, restore your data (if
available).
Note:
In some instances, RAID 10 and RAID 50 arrays may survive multiple disk drive failures,
depending on which disk drives fail. For more information, refer to the Adaptec Storage
Manager User's Guide f

Resetting the Controller

This section explains how to reset (or flash) your Adaptec RAID controller. You may want to do
this if the controller becomes inoperable, or if a firmware upgrade is unsuccessful.
To reset your Adaptec RAID controller:
Download the firmware version currently installed on your controller from
1
www.adaptec.com
Extract the downloaded files to a folder on your local hard drive (for example,
2
C:\Download\Drivers).
Create a bootable MS–DOS floppy disk and copy the AFU.exe file to it. Copy the first
3
firmware image to the same floppy disk.
Create additional bootable MS–DOS floppy disks and copy each additional firmware
4
image to its own floppy disk.
Power off your computer, disconnect the power cord, then open the cabinet following the
5
manufacturer's instructions.
Disconnect all cables from the controller, then attach a shorting jumper to the Mode 0
6
flash connector. (To locate the Mode 0 flash connector on your Adaptec RAID controller,
see the figures in
Reconnect the power cord, power on your computer, then boot to the floppy disk
7
containing the AFU.exe file (see
At the prompt, type
8
where
is the controller number.
x
Insert the other floppy disks when prompted.
9
When the flash is complete, power off your computer, disconnect the power cord, then
10
remove the jumper.
Close the computer cabinet, reconnect the power cord, then power on your computer.
11
The controller should boot correctly.
page
or Internal RAID Storage
About Your RAID Controller on page
Step
3).
a:\afu
update /c x
Chapter 10: Solving Problems
69), if more than one disk drive fails at the
or online Help.
15.)
61

Advertisement

Table of Contents
loading

Table of Contents